There are two steps which you need to take to wash a huge needle point rug. Also remember that you could have some foot traffic patterns with which to be concerned.

First off, you need to obtain some plastic sheeting to put beneath the rug if it isn’t on a water-resistant floor, for example vinyl. You’ll need some foaming carpet cleaner and a rug cleaning machine that does not have revolving bristles. If the machine contains an upholstery tool, you may use that so long as it does not have any revolving bristles. When it comes to cleaning a needlepoint rug, think of it as a gigantic piece of upholstery that must be cleaned.

Before you use the foaming carpet cleaner, do a spot test in a tiny unobtrusive location to make certain of its color fastness. Spray on the froth, then let it sit for 10 or fifteen mins, then wipe it up with a humid rag. Do not scrub the area ; wipe it up delicately. Do not continue if there is any color in the froth, other than the dirt from the surface. If the spot test turns out fine then you can use the foam on the other areas. Even though the directions on the can may instruct to clean the froth into the rug, do not do so with a yarn rug. Instead employ a damp material and work it around a little so that it will supply the surface with satisfactory coverage. Then let it sit for ten minutes or so, then wipe the surface with a humid rag to get rid of the foam. Then wipe the surface carefully with a touch wetter rag, and rinse it frequently.

After that spray sufficient froth over the entire rug so that it will spread from one end to the other. Do not spray a thick layer of foam, but just enough to cover it. Then work it around scrupulously with a damp material ( as before ), then let it sit for approximately ten mins. At that point, the foam should be just about gone. Then go over the surface with the carpet machine and lukewarm water. Suck out as much water as practical as the rug shouldn’t be sopping wet. Also, do not rub hard on the surface of the rug when it is damaged as the yarns could get damaged.

The rug should dry as quickly as possible. For the initial drying, you may hang it up outside over a line or railing. If you are not able to do so, put towels under the rug and set up a fan to blow across the top. When the rug is very close to becoming dry, take it off the line and lay it on the floor where it can dry flat. Do not walk on it or place furniture on it till the rug is completely dry. More carpet cleaning ideas here.

Comments are closed.